momentary switch independent light

Push Button Momentary Switch On/Off Push button switch used for starter, horn or other momentary functions. Solid brass construction, 5/8" diameter stem and mounts up to 1" thick dash. Rated at 15 Amps at 12v DC.Model:MP39310
15.99 USD

Plasticized body sealed against moisture and dirt. Includes two 18-gauge wire leads 12" long Fits panel through 1/2" thick
20.99 USD

Illuminated Rocker Switch - w/ 4 snap-in colored lenses SPST Off-On Independent Pilot light 25 amp load @ 12v DC. Silver contacts, brass blade terminals, a sealed black plastic housing, bezel and actuator make these switches weather resistant. Supplied with 1 each amber, clear, red and green lens. Snap-in the lens of your choice. Independent pilot light comes on with load not switch position. Snaps into 0.83" x 1.45" (21.08mm X 36.83 mm) hole. Fits panels up to .187" (4.75 mm thick)
12.99 USD

Normally off, momentarily on when button is pressed. Single Pole, Single Throw (SPST) Heavy-duty, non-corrosive construction With moisture-repellent insulators Brass case, stem, pushbutton, terminals and mounting hardware 6-36VDC Note: Only model 270876 (Cole Hersee # M626 includes the button cap)
20.99 USD

Illuminated Rocker Switch - w/ 8 snap-in colored lensesSPST On-On 1 Dependent Pilot Light & 1 ndependent Pilot light 25 amp load @ 12v DC. Silver contacts, brass blade terminals, a sealed black plastic housing, bezel and actuator make these switches weather resistant. Supplied with 2 each amber, clear, red and green lenses. Snap-in the lens of your choice. Independent pilot light comes on with load not switch position. Dependent pilot light comes on when switch is on. Snaps into 0.83" x 1.45" (21.08mm X 36.83 mm) hole. Fits panels up to .187" (4.75 mm thick) -
15.99 USD

Normally off, momentarily on when button is pressed. Single Pole, Single Throw (SPST) Heavy-duty, non-corrosive construction With moisture-repellent insulators Brass case, stem, pushbutton, terminals and mounting hardware 6-36VDC Note: Only model 270876 (Cole Hersee # M626 includes the button cap)
20.99 USD

Normally off, momentarily on when button is pressed. Single Pole, Single Throw (SPST) Heavy-duty, non-corrosive construction With moisture-repellent insulators Brass case, stem, pushbutton, terminals and mounting hardware 6-36VDC Note: Only model 270876 (Cole Hersee # M626 includes the button cap)
19.99 USD

Push Button Switch - Heavy Duty Push momentary On/Off switch. Glass reinforced polyester housing is totally impervious to salt, corrosion and rust. Electrical contacts are silver for maximum carrying capacity. Rubber moisture and dust proof boot nut included. Brass screw terminals. 30 Amps @ 12v DC.Model:MP39160
15.49 USD

Up/Down Toggle Switch for Windlass - Panel Mount This attractive, compact up/down momentary switch allows for safe windlass operation from any remote station. Rubber toggle cover ensures trouble-free performance in exposed locations.
34.99 USD

Isolates your battery banks to prevent accidental discharge of starting bankThe new E-Series switch isolates your Start and House battery circuits, preventing accidental discharge of the Starting bank and also protecting your electronics from engine starting sags and spikes. Ideal when combined with a BatteryLink Automatic Charging Relay or isolator, which will automate charging, while the new Dual Circuit Plus will simplify the switching. This new switch allows you to combine two battery banks in the ON position using a simple three-position On OFF Combine Batteries switch. The Combine Batteries position allows you to cross-connect your battery banks in the event of a weak Start battery. Ignition protected, safe for use aboard gas powered boats, and meets all ABYC battery switch standards. Long .870" studs accept up to 4/0 cables. Case design allows surface or rear panel mounting. Fits all Perko and Guest low amperage battery switch hole patterns. Luminous label allows low-light reading and tactile textures on face let you know the knob position by feel only. Number of Positions: Three Alt. Field Disc: No Continuous Amps: 300A Max. Momentary Rating:1500A Switch Material: Lexan polycarbonate Terminal Material and Size: Tin-plated copper, 3/8" (10mm) Switch Dimensions: 3.85"L x 3.85"W x 3.10"H Approvals: UL Listed. Meets UL 1500, SAE J1171, CE Warranty: Five years
52.99 USD